Duet3D Logo

    Duet3D

    • Register
    • Login
    • Search
    • Categories
    • Tags
    • Documentation
    • Order

    Need Help with Configuration Files

    Firmware installation
    3
    3
    857
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • zstudios
      zstudios last edited by

      I just uploaded some configuration files onto the Duet Wifi courtesy of another user that has the same printer. While it was uploading via the web interface, the server crashed. I was unable to access it through wifi and pronterface. I suspect it has to do with one of the files that I uploaded. I then proceeded to reset the firmware through sam-ba and was successful in doing so. Afterwards, there were no problems connecting to pronterface and no problems invoking M503 to check on the config file. The problem arises when I invoke M552 S1. It says wifi starting, but hangs pronterface. I let it run for a few minutes and it still does not work. As mentioned above, this happened when I uploaded an entire sys folder into the board. Anyone have the stock configurations of the sd card so that I can effectively get a stock "new" board? Thanks

      1 Reply Last reply Reply Quote 0
      • Jackal
        Jackal last edited by

        Have you followed the step by step guide?
        https://duet3d.com/wiki/Getting_connected_to_the_Duet_WiFi

        1 Reply Last reply Reply Quote 0
        • dc42
          dc42 administrators last edited by

          I suggest you copy the correct DuetWiFiserver-xxx.bin file to the SD card on a PC, then put the SD card back in the Duet, start the Duet, and send M997 S1 to re-flash the wifi module.

          If you have flashed version 1.18.2 or earlier firmware, you need DuetWiFiServer-1.03ch.bin. if you have flashed version 1.19beta6 then you need DuetWiFiServer-1.19beta1.bin.

          Duet WiFi hardware designer and firmware engineer
          Please do not ask me for Duet support via PM or email, use the forum
          http://www.escher3d.com, https://miscsolutions.wordpress.com

          1 Reply Last reply Reply Quote 0
          • First post
            Last post
          Unless otherwise noted, all forum content is licensed under CC-BY-SA