Neopixel issue D3+rpi 3.2b1



  • We are using Duet3/RPI and currently running 3.2b1. I have the following in my config:

    M150 X1 F3000000
    M150 R0 U85 B255 P64 S57
    M150 R0 U85 B255 P64 S57
    

    Note the two lines with the same command - if I send it once (in the config or through the console), it never works the first time, I have to send it a second to get them to start working.

    This feels wrong, but again, it could be I don't know what I'm doing. Thanks


  • administrators

    If you insert a short G4 delay command between the M150 X1 command and the second M150 command, does it work without the third M150 command?



  • @dc42 No - that doesn't correct it. I just tried several times up to 1 second but it still does not enable unless I run a second command.


  • administrators

    Thanks, I'll look into this.


Log in to reply