RRF3 & P0 to P1 must be in clockwise...

[Rudy2A]

Hello,

Since switching to RRF3, I keep getting this error ... Probe points P0 to P1 must be in clockwise order starting near minimum X and Y.
I can't figure out where this came from, especially since with RRF2 everything was working fine.

Thank's

[dc42]

That means it has reverted to the old-style bed compensation. What is your G32 file used for? If it is for true bed levelling, check that the number of points declared in M671 is the same as the number of Z motors declared in M584.

[Rudy2A]

@dc42 said in RRF3 & P0 to P1 must be in clockwise...:

That means it has reverted to the old-style bed compensation. What is your G32 file used for? If it is for true bed levelling, check that the number of points declared in M671 is the same as the number of Z motors declared in M584.

Solved, I just forgot to put my M671 back into my new Config.g file!

Thanks for enlightening me.