1. Home
  2. Categories
  3. Firmware installation
  4. Error: Short-to-ground on drivers 0 Error: Over temperature shutdown

Error: Short-to-ground on drivers 0 Error: Over temperature shutdown

  • tangent1001

    I blew the x driver on my board. I remapped my axes and removed the old driver with a soldering iron. Everything worked fine until I updated to the new firmware and now I get spammed with

    Error: Short-to-ground on drivers 0
    Error: Over temperature shutdown on drivers 0

    It still heats up and moves but that is kinda bothersome. Can I disable this?

    0
  • dc42
    administrators

    Only by installing a new driver chip. It's possible that connecting a small signal Schottky diode between the CS and SDO pads for that chip (cathode to CS) might also work, but I haven't tested it.

    0
Log in to reply
 
Unless otherwise noted, all forum content is licensed under CC-BY-SA