M303 result message M307 inconsistent with config-override.g

[louvanna]

Was asked to repost this here. ( same title)

3/7/2021, 10:28:48 AM M115
FIRMWARE_NAME: RepRapFirmware for Duet 2 WiFi/Ethernet FIRMWARE_VERSION: 3.2.2 ELECTRONICS: Duet WiFi 1.02 or later FIRMWARE_DATE: 2021-02-11

The result of an heater auto-tune provides a prototype line for inclusion in a config, or use M500 to write into config-override.g.

The message and the written lines are inconsistent. Not sure it matters .

3/7/2021, 9:46:34 AM Auto tuning heater 1 completed after 3 idle and 5 tuning cycles in 347 seconds. This heater needs the following M307 command:
M307 H1 R3.758 C126.5 D7.32 S1.00 V12.2
Send M500 to save this command in config-override.g

The line in the config-override.g is different.

Numerical precisions
inclusion of B0

M307 H1 R3.758 C126.499:126.499 D7.32 S1.00 V12.2 B0

Not being fully aware of the defaults, etc., so I cannot say that this important. This may simply be 'house keeping'.