3.4 b6 Heater Faults but still printing.
-
Using on Duet3 MB6HC +2xEXP3HC, tools and heaters being on one of the 3HCs.
Got a Heater Fault while printing but I can't see anything inside the log and nothing appeared in the console.
It was caused by slow heating when I printed fast, >30mm3/s and put the temp up by 10 degrees.
The heater stopped but the print did not. -
@typqxq this is a known issue: heater faults on tool or expansion boards shut down the heater and report their status as "fault", but RRF does not pause the print. This is one of the few remaining items on my TODO list before release 3.4.0 is considered complete.
