[3.5.0-rc.1] Cant resume from M226

[DavidG_68kg_PLA]

Hey guys,

when i pause the print via post processing in the slicer with M226, i can click resume, the printhead moves back to point where it should restart the print but then immediately pauses the print again without any printing. This seems to be an infinite loop.

Exact same .gcode, which works fine on 3.4.6:

...
G1 X71.009 Y-164.250 E3.24055
G1 X81.512 Y-179.250 E2.54886
G1 X179.250 Y-179.250 E13.60448
G1 X179.250 Y-156.750 E3.13186
G1 X24.311 Y-156.750 E21.56658
G1 X19.811 Y-161.250 E0.88582
G1 X4.689 Y-161.250 E2.10479
G1 X4.189 Y-161.250 F3240
M226 ; Z = 0.6000
M106 S120 P0
G1 Z0.6000 F9000
G1 X-0.311 Y-156.750 E0.88582 F5400
G1 X-156.750 Y-156.750 E21.77537
G1 X-156.750 Y-53.205 E14.41285
G1 X-161.250 Y-48.023 E0.95524
G1 X-161.250 Y-30.192 E2.48202
G1 X-156.750 Y-25.011 E0.95524
G1 X-156.750 Y49.011 E10.30330
G1 X-161.250 Y54.192 E0.95524
G1 X-161.250 Y72.023 E2.48202
G1 X-156.750 Y77.205 E0.95524
G1 X-156.750 Y179.250 E14.20406
G1 X-179.250 Y179.250 E3.13186
...

My Setup:
Deltaprinter
MB6HC
SBC
2x 1LC; 1x 1HCL (on one of the delta axis)

BTW: input shaper on rc1 is giving me good results for the first time!

[dc42]

@DavidG_68kg_PLA I've just tested M226 on my delta running the candidate 3.5.0-rc.2 binary and it is working. So please try rc2 when we release it, which I hope will be tomorrow.

[DavidG_68kg_PLA]

@dc42 Hi David,

thats awesome!
I'd even call it a "desperate need" for M226 working together with the good shaper results over here

Looking forward to it!