Thank you I think that will help,

Pegaso

Hello,
what are the correct values, for the stepper-motors if I want to use 256 microsteps on the "Anycubic Predator" (X,Y,Z and E0)?
The values in the original Firmware are 0,0125 for X,Y,Z and 0,00256 for the E0.
Can I use 1 / 0,0125 and 1 / 0,00256, are the values with 256 microsteps the same?
The preset for that values in that config-asistand on Page two are 80 for XYZ and 4000 for E0.

How can I find the correct settings, to fill in this page and the following.

Thanks in advance for your help.

Pegaso