When I opened it up there was some ground up filament in the sensor. I haven't done any long running prints but this looks to have been the problem. Thanks!

@dc42 Thanks for pointing that bit out. I had missed that on the docs site. I filed it down some and it seems to be at a more acceptable range.

When I opened it up there was some ground up filament in the sensor. I haven't done any long running prints but this looks to have been the problem. Thanks!

I am getting weird values and not enough movement alerts from the magnetic filament sensor lately. I had been using it with some success until today. I was wondering if anyone had any ideas. I am running Duet 2 wifi with firmware version 3.1.1.

M591 D0
Duet3D rotating magnet filament monitor v3 on pin e0stop, disabled, sensitivity 24.55mm/rev, allow 20% to 140%, check every 45.0mm, version 3, mag 130 agc 120, measured sensitivity 15521.55mm/rev, min -33% max 476% over 1546.1mm

Thanks in advance