Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Invert Chamber heater signal

    Scheduled Pinned Locked Moved
    Duet Hardware and wiring
    2
    3
    237
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Romundefined
      Rom
      last edited by

      Hi! I have chamber heater on pin8 (Heater3), but it logical 0 active. Can I invert signal in G-Codes or somewhere else by software? I have ULN2003 connected to pin8 and Chamber power on by command M141 S0, and power off by M141 S100.

      1 Reply Last reply Reply Quote 0
      • dc42undefined
        dc42 administrators
        last edited by

        In RepRapFirmware 3 you can invert any pin, see https://duet3d.dozuki.com/Wiki/RepRapFirmware_3_overview.

        Caution, the heater outputs are pulled high at power up by the internal pullup resistor in the MCU. That's why we used active low signals. You can defeat the internal pullup using a pulldown resistor. Suitable values are 2.2K to 4.7K.

        Duet WiFi hardware designer and firmware engineer
        Please do not ask me for Duet support via PM or email, use the forum
        http://www.escher3d.com, https://miscsolutions.wordpress.com

        1 Reply Last reply Reply Quote 0
        • Romundefined
          Rom
          last edited by

          will try it. thank's!

          1 Reply Last reply Reply Quote 0
          • First post
            Last post
          Unless otherwise noted, all forum content is licensed under CC-BY-SA