Corexy Z offset
-
i dont see where the trigger height of 0.7 is set.
try deleting all G10 commands from the config and overwrite
-
nothing has changed
-
Trigger Height: 0.7 mm
-
Thank you very much Veti for your help today!, I hope that tomorrow you can come up with something new
Regards Chris -
lets make sure you are editing the correct config.g
issue the command M906 and post the output.
then decrease the motor current in the config.g by 100, restart
issue the command M906 and post the output. -
Ok, I'll do it after work
-
@veti said in Corexy Z offset:
M906
ok I am here, welcome back
M906
Motor current (mA) - X:800, Y:800, Z:800, E:800:800, idle factor 30%M906
Motor current (mA) - X:700, Y:700, Z:700, E:700:700, idle factor 30% -
@chris11 said in Corexy Z offset:
G31 P25 X0 Y-29.30 Z0.95
what does the system properties show after you put this command in manually into the console?
-
Type:
Digital Switch (5)
Trigger Height:
0.7 mm
Trigger Value:
500 -
-
i am stumped on this. i have no idea why the G31 command would be ignored.
maybe someone else has an idea.
-
@chris11 said in Corexy Z offset:
G31 P25 X0 Y-29.30 Z0.95
and I times 10 more, I know it's very annoying
-
which firmware version are you running?
-
Firmware Name: RepRapFirmware for Duet 2 WiFi/Ethernet
Firmware Electronics: Duet WiFi 1.02 or later
Firmware Version: 2.03 (2019-06-13b2)
WiFi Server Version: 1.23
Web Interface Version: 1.22.6 -
Veti, thank you very much! for your help and time devoted to me.
Maybe someone else has what ideas?? -
ok gentlemen, after 8 hours of searching the internet, and after hundreds of read posts I found a solution to my problem, very trivial reason as usually happens when you can not find any solutions.
I set command in the wrong order here is the explanation:
That can happen if you put the G31 command earlier in config.g than the M558 command. This is because RRF stores different G31 parameters for different types of Z probe, to allow you to use more than one probe. -
the manual G31 should not have been affected by this
from the manual of G31
Tnnn (RepRapFirmware 1.17 and later) Z probe type to which these parameters apply, defaults to the current Z probe type as defined by M558 P parameter
@dc42 is that a bug?
-
I don't know, but the most important thing is that everything started working fine. Veti thank you again for the time devoted to me, I am very grateful for that!
-
could anyone help me in setting the heightmap, after auto bed compensation I gets a message that 25 points probed, min error -0.067, max error -0.005, mean -0.042, deviation 0.020 Height map saved to file heightmap.csv,
it means everything is fine, but after printing starts it gets this message:
Error: M375: Height map file bareplate.csv not found -
search all your .g files in the sys folder for that string. also have a look at the gcode you are printing.