Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Duet 2 Ethernet, BLTouch and double Zprobe leveling

    Scheduled Pinned Locked Moved
    Duet Hardware and wiring
    2
    2
    190
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • escknxundefined
      escknx
      last edited by

      Hello everyone.
      I'm new to this, so please excuse my ignorance I may ask dumb questions.

      I have Creative3D Elf corexy printer coming in a week and want to pre-configure Duet 2 Ethernet.

      That printer comes with Marlin2 32bit board and uses their own developed double Z axis auto leveling.

      According to manufacturer BLTouch is not supported on stock board because they use 2 x Zprobes for each axis motor in order to make this fancy auto leveling and there's not extra port for BLTouch.

      I'm trying to figure out how to make this auto leveling + BLTouch work with Duet.

      I'm looking into Duet's wiring scheme and I see one Z stop port in the midlle of the board, and another Z probe at the bottom.

      So I connect BLTouch to Zprobe, but where other 2 stock probes go? Or 2 is max for Duet?

      1 Reply Last reply Reply Quote 0
      • Vetiundefined
        Veti
        last edited by

        you dont need them for the duet.
        see
        https://duet3d.dozuki.com/Wiki/Bed_levelling_using_multiple_independent_Z_motors

        1 Reply Last reply Reply Quote 1
        • First post
          Last post
        Unless otherwise noted, all forum content is licensed under CC-BY-SA