Always different Z probe trigger height...
-
you dont have a M501 in your config. so those will be ignored.
-
@veti ouh man, I pasted not full config, special for low text... )))
-
Baby stepping don't worked too!
I set -2mm, but nozzle don't changed position.... -
@spax said in Always different Z probe trigger height...:
M208 Z0.1 S1 ; Set minimum Z
because you disallowed it
-
@veti But before that, everything worked well ... really don't know what happen...
And why is Z position 0.1 above the bed by 2 mm. I think Auto Calibration don't work well.. -
@spax said in Always different Z probe trigger height...:
And why is Z position 0.1 above the bed by 2 mm.
that would indicate a wrong z trigger height
-
@veti I do all what in first post and correct config.g after ....
-
does your probe have problems?
check the repeatability
https://forum.duet3d.com/topic/6962/m48-measure-z-probe-repeatability-and-print-to-serial-output
-
@veti said in Always different Z probe trigger height...:
does your probe have problems?
I think no.
check the repeatability
It is repeatability
M98 P"0:/macros/M48"
G32 bed probe heights: 0.088 0.095 0.088 0.088 0.088 0.095 0.095 0.088 0.101 0.095, mean 0.092, deviation from mean 0.004 -
hmm?
problem with your endstops?
do a the macro.
then home with G28 and doe the macro again -
@veti omg....
G31 P500 X15 Y15 Z3,6
I wrote a comma instead of a dot
Now I heat a bed and try again auto calibrate. -
Ok, now started print cube 20x20, first layer is well)
-
@spax said in Always different Z probe trigger height...:
I wrote a comma instead of a dot
yes i told you about that several posts ago. you said you changed it in config.g
-
@veti oh yes, my mistake, I misunderstood you. I thought you mean about value...
