Correct power supply

knehighprinter

Hi all I'm from Australia i have a creality Cr10 s4 standard.
I just wanted to know if. A
mean well power supply rsp-320-24 work with cr 10s s4 and duet wifi borad
Because I already have this one spare to use

0

Danal

@knehighprinter said in Correct power supply:

rsp-320-24

Yes.

A lot of people run 24V, it does wonderful things for the stepper motors and drivers. It is well within the limits of the Duet board itself. ASSUMING that you use 24V bed heater, hot-end heater, and fans.

(There are various ways to run 12V fans or even 5V fans if you really wish... they are too long to document here. Heaters, on the other hand, pretty much have to be 24V.)

knehighprinter

@Danal thank you very much for the information

Phaedrux

https://duet3d.dozuki.com/Wiki/Connecting_and_configuring_fans

https://duet3d.dozuki.com/Wiki/Choosing_the_power_supply

These may help.