Problem with temperature sensor mark 2000°
-
The sensor is this one :https://e3d-online.com/pt100-temperature-sensor and i'v tried to change the config file by typing M305 P1 X200 at the place of the heater
-
did you verify the resistance of the pt100 sensor?
did you connect it to the correct terminal?
just checking. you do have the duet daughterboard and not the e3d daughterboard?
-
-
-
when you enter M305 P1 X201 in the console(not the config) does it also show 2000?
-
-
that means it cant talk to the dauthterboard.
did you connect it the correct way round?
-
-
that is the wrong way.
compare the documentation
https://duet3d.dozuki.com/Wiki/Connecting_PT100_temperature_sensorsthe spacer should line up
-
Ok but right now the screen show -0.2°
-
@kyll said in Problem with temperature sensor mark 2000°:
-0.2°
thats the 100 ohm resistor. now switch the channel
-
On it's working thank you so much
