Stop Z from going beyond 0
-
Is it possible to force the machine to not go beyond 0 on the z axis?
On a few occasions now we've crashed the bed into the nozzle and other equipment because the manual jog controls will allow the machine to go into the negative Z space.
Normally this isn't too big a deal but on our large volume machine the z-axis screws are very powerful and a lot of damage occurs.
Anyway, a soft z-stop would really help me out but I can't seem to find a setting for this.
Worst case we'll go to hard stops but that has its own issues.
Thanks.
-
Have a look at the axis limits in your config:
https://duet3d.dozuki.com/Wiki/Gcode#Section_M208_Set_axis_max_travel
-
Ha! Why do I have my M208 set to Z-780??
️This would have saved my buns twice now.....I never even saw that.
X and Y are set correctly...go figure.
Been working on this beast sporadically for almost a year...should be printing this week finally. Mind the mess and dangling wires!
