Error in M502 wiki?
-
https://duet3d.dozuki.com/Wiki/Gcode#Section_M502_Revert_stored_parameters
This command resets all tunable parameters to their values, as set in config.g. This doesn't reset any parameters stored in the sys/config-override.g, so it must be followed with M500 if you want to do that.
Should that be
M501at the end? -
no you want M500 to save the values to config-overwrite
M501 loads the values from config-overwrite.
If you run M502 and then M501 you would undo the changes from M502
-
Gotcha! Odd wording to me, but makes sense as you put it
-
I agree, the wording was odd. I have just changed it; do you find the new wording clear?
-
Looks good
