Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Z Offeset Adjustment Question

General Discussion

2

2

86

Log in to reply

undefined

psyfor
last edited by

I am noticing that my Z Offset is slightly high. Is it better to go through the BLTouch calibration again or make small adjustment to the Z Value in G31 directly in config?
undefined 1 Reply Last reply
Reply Quote 0
undefined

Veti @psyfor
last edited by

@psyfor
while printing use babystepping to make the final adjustment for a perfect first layer, then apply the final value for babystepping to the Z offset.
1 Reply Last reply
Reply Quote 1

1 / 1