Using PL08-N probe getting bad command r0.2

CarlJ

homeall.g This is a new setup on corexy printer (voron)
Been weeding out problems as I go, been slow but productive till this.

Message response is Bad command r0.2 when I activate z_probe_ macro.

[0_1581953284105_config](Uploading 100%)

homeall.g

activate_z_probe.g

go_to_bed_center.g

Firmware Name: RepRapFirmware for Duet 2 WiFi/Ethernet
Firmware Electronics: Duet WiFi 1.02 or later + DueX5
Firmware Version: 2.05.1 (2020-02-09b1)
WiFi Server Version: 1.23
Web Interface Version: 1.22.6

Going to use probe for homez is the plan, need to figure it out also.

Any help or guidance is appreciated.

CarlJ

dc42

Your file activate_z_probe.g comprises 4 good lines, then 57 blank lines, then a final line that reads "r0.2". That final line provokes the error message.

CarlJ

Very good, guess need to scroll down alot to see it.
Fixed that.
Now to proceed to next hurdle. Usually I find what I need looking thru the posts. So I don't make many requests.
It's been a learning experience.

Thank You