Cannot get in Duet 3 web server after upgrade

jdumoulin

@bearer said in Cannot get in Duet 3 web server after upgrade:

thats not how troubleshooting works

Well the 4th cable didnt make a connection at all. It could not find the device.

dc42

This is worth a try:

Fit the Erase jumper
Power up the Duet
Press the Reset button
Without powering down, remove the Erase jumper
Try to flash the firmware using Bossa

jdumoulin

@dc42 said in Cannot get in Duet 3 web server after upgrade:

Without powering down, remove the Erase jumper

I did that this morning. Bossa com port did show up. No progress for over an hour now Capture Bossa.JPG

deckingman

@jdumoulin From the wiki https://duet3d.dozuki.com/Wiki/Installing_and_Updating_Firmware#Section_Fallback_procedure_Num_3.................

If using Bossa:

Check boxes Erase all, Lock, and Boot from Flash

You screen shot shows no check marks on the erase all or lock (boot from flash is hidden).

jdumoulin

@deckingman said in Cannot get in Duet 3 web server after upgrade:

You screen shot shows no check marks on the erase all or lock (boot from flash is hidden).

Still no love from the Duet Capture Duet 3 again.JPG

dc42

Does it just sit there doing nothing, or does it eventually give an error message?

jdumoulin

@dc42 said in Cannot get in Duet 3 web server after upgrade:

Does it just sit there doing nothing, or does it eventually give an error message?

It just sits there. No error message

dc42

I'm sorry, I think there is a problem with the processor on that board. Please ask your supplier to replace the Duet 3.

A Former User

As bossac on the pi connects, and identifies the cpu could it be worth while trying to lower the baud rate? Seems its fixed at 921600 but code does allow for baud rates down to 1200. But does the SAM7x support lower baud rates? (or does the usb thing make it a moot point?)

dc42

I've just found another tool for programming flash memory on a SAME70 at https://github.com/atmelcorp/micro-sam-ba. Unfortunately there is no executable file provided. I'll try building it later today, unless someone else beats me to it.

A Former User

Needs to be built for cygwin if to be used on windows; for the pi its just git clone and make, no dependencies to deal with and the default image has the build tools it seems.

Not sure if the last command is needed to get the processor out of boot from ROM mode, can't test it. (and I just realized this was the wrong thread, but if OP has a PI...)

git clone https://github.com/atmelcorp/micro-sam-ba.git
cd micro-sam-ba/
make
./usamba /dev/ttyACM0 erase-all
./usamba /dev/ttyACM0 write /opt/dsf/sd/sys/Duet3Firmware_MB6HC.bin 0x400000
#./usamba /dev/ttyACM0 gpnvm set 1