Print Frozen - RRF3.01-RC12 and DSF 2.2.0

[chrishamm]

@jay_s_uk The fix will most likely resolve your problem, too. Please give it a try if you can.

[jay_s_uk]

@chrishamm

Great stuff. I'll give it a go

[mwwhited]

@dc42 How long should this update take to apply?

it's been saying "Please wait while updates are being installed... " for over 15 minutes.

[mwwhited]

I'm now getting "Timeout while waiting for transfer ready pin" when I try to start DuetControlServer in debug mode.

[jay_s_uk]

I got that when I installed both the expansion and main board updates. It started working again once I fully powered off the machine

[dc42]

It should be very quick, like any other firmware update. I suggest you try updating the firmware using Bossa instead.

[mwwhited]

Okay, I'm back up and running after wedging a USB cable into my controller (guess I should have left some more room to work with.) I'll let it run and let you know how it goes.

[jay_s_uk]

I've updated the firmware on my boards but not had chance to run a print yet. Too busy tweaking my tpre and tpost files.

[mwwhited]

I haven't seen any more issues today... but I'll continue to keep and eye on it.

-Thanks,
Matt

[mwwhited]

Didn't fix the issue. I was working on my toolhead scripts this morning and RPi froze.

[chrishamm]

@mwwhited Please try out the latest software bundle, there have been some more improvements since then. If you do see more freezes, please check the log of DCS (sudo journalctl -u duetcontrolserver -e).