Heated bed on large delta printer

[Bewaren]

Afternoon all, I am building a new delta style printer that has a 800mm diameter build plate and I am using the new Exoslide rails on 2020 extrusions with 45x45 extrusions supporting the structure as it is just over 2m tall. The issue I am facing is the bed heating. I am wanting to use a 220v 2000w heating element (Linked below) with my Duet3D Ethernet board, is there any way I can use the duet to power the bed aswell as control and monitor the temperature?

https://www.aliexpress.com/item/32885002691.html?spm=a2g0o.productlist.0.0.743651f71zlK9r&algo_pvid=f07ff5c2-ba5f-4c00-bd1d-e3a39042e5e1&algo_expid=f07ff5c2-ba5f-4c00-bd1d-e3a39042e5e1-9&btsid=0ab6fb8315904926129708912eb1c0&ws_ab_test=searchweb0_0,searchweb201602_,searchweb201603_

Hope you are all well

Regards, Bailey

[dc42]

Yes, see https://duet3d.dozuki.com/Wiki/Choosing_a_bed_heater#Section_Mains_voltage_AC_bed_heater.