IR Probe issue after 3.1.1 update from 3.0
-
Is this a Duet IR sensor or a clone? Was it purchased recently?
-
its a Duet sensor.. not clone. purchased 4 months ago
-
I reduced the trigger value from 500 down to 400 and it seems to be working again. before updating firmware it worked fine at 500
-
@Adamfilip said in IR Probe issue after 3.1.1 update from 3.0:
I reduced the trigger value from 500 down to 400 and it seems to be working again. before updating firmware it worked fine at 500
Is it working better now?
-
no, I spoke too soon!
It does trigger more consistently but its all over the place now
l) -
Should i use M558 P2 instead of P1?
-
I ran a Mesh compensation sequence and I noticed that when it was probing. While watching the Z probe values.. sometimes the Probe value was around 100 between probings and other times it was zero.. makes me wonder if there is a wire issue
-
What's your wiring like? Photo? Is it running alongside anything else?
-
I checked the wiring and one of the wires in the dupont connector was loose. I adjusted it and now its working properly. So I will consider this resolved. thanks for helping look into this.
-
Glad you figured it out.
