HOW change the speed of my bed calibration G32 AND G29
-
ihave dde direct drive kit this is th right X Y OFFSET ,
but iget this error
Warning: Skipping grid point (0.0, 160.0) because Z probe cannot reach it
Warning: Skipping grid point (0.0, 200.0) because Z probe cannot reach it -
@Roei3d said in HOW change the speed of my bed calibration G32 AND G29:
M208 X245 Y210 Z240 S0 ; set axis maxima
G31 P500 X38.2 Y0 Z1.08 ; set Z probe trigger value, offset and trigger height
M557 X0:235 Y20:225 S30 ; define mesh gridyou need to limit your grid taking into account the probe offset
M557 X40:245 Y20:225 S30 ; define mesh grid
-
@Veti this is my problem ido home all
After it g29 and its not start from x0 it dont go all to the end stop
I upload to you tube https://youtu.be/7FL0kCXGIHM -
nice the new metal kit for the ender.
again it does not need to go to the endstop for probing.
-
@Veti thnks its blv ender 3
itray this M557 X40:245 Y20:225 S30 and it goo out of the bed -
ok change to this
M208 X235 Y210 Z240 S0 ; set axis maximaM557 X40:235 Y20:225 S30 ; define mesh grid
ender 3 is max 235. why did you define 245?
-
@Veti hi clean the nozzle with a brush I put aside on x245
if ido M557 X40:220 Y20:225 S30
no its work good no error its ok ?
26.9.2020, 18:34:28 G32
49 points probed, min error -0.347, max error 0.734, mean 0.164, deviation 0.288
Height map saved to file heightmap.csv -
@Roei3d said in HOW change the speed of my bed calibration G32 AND G29:
M557 X40:220 Y20:225 S30
yes.
post a picture of the heighmap.
-
This post is deleted! -
-
i am not sure of you are twisting your bed. try adjusting the top right to be in line with the other sides
-
@Veti ok thnks for your help
