Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    SD extension via CONN_SD design questions

    Scheduled Pinned Locked Moved
    Third-party add-ons
    1
    2
    182
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Zhang Jianyuundefined
      Zhang Jianyu
      last edited by

      Hello all,

      I want to make a SD card extension to plug into CONN_SD on Duet 2 wifi/eth, basically just extending the SPI signals 150-200mm to an SD socket.

      I don't have much electronics design experience, so I have a couple basic questions if anybody knows:

      1. Would any passive components be recommended at the SD socket when extending in this way?

      2. Related to the Duet, would running a PanelDue via the 4-wire cable, and a separate SD extension (rather than using PanelDue SD slot) cause any trouble?

      Here is a picture of what I have in mind: Imagine a cable connecting this to CONN_SD. (no SD card holder model is in KiCad so it only shows the pads and connector).
      9c44abfa-5328-490d-bb28-b831fcebbe1e-image.png

      Any guidance is appreciated. Thanks!

      1 Reply Last reply Reply Quote 0
      • Zhang Jianyuundefined
        Zhang Jianyu
        last edited by

        Also, here is the schematic i have made (pardon the sideways power ports):
        c32e1843-6e5a-4b23-946d-d8d8ba3da4a4-image.png

        1 Reply Last reply Reply Quote 0
        • First post
          Last post
        Unless otherwise noted, all forum content is licensed under CC-BY-SA