Duet Maestro (Crane Quad) BLTouch Setup Issues
-
So, I have spent many hours reading other forum posts and I just cant get this to work. There is no override file at all on a crane quad. I have 5 volts to the BLTouch. Mod is working fine as the pin activates and moves up and down. I tested voltage on Probe in and its getting 4.5 volts when activated by the BLTouch. But, Web interface refuses to register anything above 0 for z probe. Just unsure what to do at this point. I am not looking to use this as my z. Just to get a mesh bed going for leveling purposes.
Hardware: Duet Maestro 1.0 (duetmaestro100)
Firmware Firmware: RepRapFirmware for Duet 2 Maestro 2.05.1 (2020-02-09b1)
Duet Web Control 3.2.0-beta3
BL Touch V2Pin Down works fine M280 P64 S10
Pin Up works fine M280 P64 S90config.g
M558 P9 H5 F100 T2000 C64
G31 P25 X0 Y0 Z0 -
@Tylerun said in Duet Maestro (Crane Quad) BLTouch Setup Issues:
Web interface refuses to register anything above 0 for z probe
that is normal for a bltouch. when triggers it just for a split second and you can not see it in the web control.
have you adjusted your homing files for bltouch (g30)?
-
So even when down via my macro it should report 0? Just want to confirm as i had it trying to ram into the glass a bit ago. Also its homing via the z endstop which is what i want still. I have completed the g30 command.
-
yes
to test it. put the gantry high, when the gantry moves down trigger the bltouch by hand.
if it does not stop, cut the power.post your homall.g
-
@Tylerun said in Duet Maestro (Crane Quad) BLTouch Setup Issues:
. Also its homing via the z endstop which is what i want still.
why did you get a bltouch then?
-
To have the height map. For "True Bed Leveling"
-
Huh. I reflashed tehj firmware and it seems to be working now. Strange