• Tags
  • Documentation
  • Order
  • Register
  • Login
Duet3D Logo Duet3D
  • Tags
  • Documentation
  • Order
  • Register
  • Login

Bug

Scheduled Pinned Locked Moved
General Discussion
1
3
559
Loading More Posts
  • Oldest to Newest
  • Newest to Oldest
  • Most Votes
Reply
  • Reply as topic
Log in to reply
This topic has been deleted. Only users with topic management privileges can see it.
  • undefined
    Styler93gsx
    last edited by 11 Jul 2017, 18:09

    I Think I just discovered a bug. For some reason. I tried to reconfigure my printer with the RRC configuration tool. After re uploading my motors make sounds but wouldn't move. I noticed that in the config file of when it used to work I had to put 1200 mA instead of 1.2. Well the new file configured to 1.2 which is what I would suspect if the comment section to the right said amps. Well I changed it back to the 1200 mA and they are working fine again.

    1 Reply Last reply Reply Quote 0
    • undefined
      Styler93gsx
      last edited by 11 Jul 2017, 18:12

      Wow I'm and idiot. I went back and looked at the configuration tool and it says 800 mA default and it was me who actually put 1.2.

      Just delete this thread.

      I acutally looked at the back of my motor and saw 1.2 amps and didn't convert to mA.

      1 Reply Last reply Reply Quote 0
      • undefined
        Styler93gsx
        last edited by 11 Jul 2017, 18:13

        Maybe if the min value was say 3 mA then no one else would make this mistake.

        1 Reply Last reply Reply Quote 0
        3 out of 3
        • First post
          3/3
          Last post
        Unless otherwise noted, all forum content is licensed under CC-BY-SA