Duet3 6HC input wiring

[abtiwari.1989]

Hi,
Can i connect 24 volt pnp sensor output to input pin of duet3 6 hc borad for end stop

[Veti]

see
https://duet3d.dozuki.com/Wiki/Duet_3_Mainboard_6HC_Hardware_Overview

Inputs are 30V-tolerant

also see
https://duet3d.dozuki.com/Wiki/Connecting_a_Z_probe#Section_PNP_output_normally_open_inductive_or_capacitive_sensor

Note: on the Duet 2 Maestro and on revision 1.04 or later of Duet 2 WiFi or Duet 2 Ethernet, you can instead connect the output of the sensor directly to the IN pin of the Z probe connector because the IN pin is 30V-tolerant. You must still connect a pulldown resistor between IN and GND of the Z probe connector. 10Kohms is a suitable value.

this applies to the duet 3 as well

[abtiwari.1989]

@Veti thanks for prompt response