Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Extruder heater outputs fuse

Duet Hardware and wiring

2

2

130

Log in to reply

undefined

yrud
last edited by 27 Apr 2021, 13:06

Hy there.
I'm wondering which of two 15A fuses (1 or 2 in the picture) is connected to OUT_1, OUT_2 and OUT_3? Planing on using large steppers and a SuperVolcano 80W heater(s) so it adds up uncomfortably close to 15A.
undefined 1 Reply Last reply 27 Apr 2021, 13:21
Reply Quote 0
undefined

dc42 administrators @yrud
last edited by 27 Apr 2021, 13:21

It's fuse #1.

How are you calculating the VIN current raw for the stepper motors? It may be much less than you think.
Duet WiFi hardware designer and firmware engineer
Please do not ask me for Duet support via PM or email, use the forum
http://www.escher3d.com, https://miscsolutions.wordpress.com
1 Reply Last reply
Reply Quote 0

1 / 1