Trigger on/off toggle

cosmowave

Hello,
in my config.g i have defined a trigger with:

M950 J0 C"!^E0STOP"									; Input 1 uses e1Stop pin, inverted, pullup enabled (FlowSensor)
M581 P0 T2 S0 R0									; invoke trigger 2 when an active-to-inactive edge is detected on input 1, anytime

I'd like to have a macro on the touchscreen for enable/disable the trigger with toggeling behavior.
Is it possible to temporarly enable/disable the trigger? I think, it should be possible to do it with a variable. But eventually, there is another easy command to read the actual state of the trigger and set the trigger to active/inactive?

Thanks for your help

PaulHew

@cosmowave Have you seen this, it might help with what you are trying to achieve
here

REgards
Paul

cosmowave

@paulhew Thanks, but i have seen that.
But i could not found the triggers in the OM!