After updating to 3.4.0beta2: faulty heater 1, -273.1C.

[jbarros]

@dc42
Temps good on test2

[dc42]

Thanks again! Please try firmware Duet3Firmware_TOOL1LC_test3.bin at https://www.dropbox.com/sh/heg82sqvhpqb670/AAARGaD-zLptgnHj-PiqiwQBa?dl=0. If the temperature readings are OK, please use M115 B<can address> to confirm that the firmware installed on the tool board is the test3 version.

[jbarros]

@dc42

Temps good.
I always check the firmware version but here it is:

Duet TOOL1LC firmware version 3.3+test3 (2021-08-21 11:42:11)
Bootloader ID: SAMC21 bootloader version 2.3 (2021-01-26b1)

[dc42]

@jbarros thanks! Please try test4 at the same location.

[jbarros]

@dc42

Still OK

I'm leaving for the beach now, can only test further later today

[dc42]

@jbarros thanks, I'll prepare test5. Have a nice time at the beach!

[dc42]

@jbarros, test5 is now available, same location https://www.dropbox.com/sh/heg82sqvhpqb670/AAARGaD-zLptgnHj-PiqiwQBa?dl=0.

@Sotidii, please test these files too if you and your machine are free.

[Sotidii]

@dc42

test3 , test4,test5 ==OK!

[dc42]

@sotidii thanks! test6 coming soon.

[dc42]

@sotidii please try the test6 file from the same location.

[Sotidii]

@dc42
test6 =OK!

[CadetC]

@dc42
Test 1 -OK
Test 2-OK
Test3-OK
Test4-OK
Test5-OK
Test6-OK

m122 b121
Diagnostics for board 121:
Duet TOOL1LC firmware version 3.3+test6 (2021-08-21 13:29:44)
Bootloader ID: SAMC21 bootloader version 2.3 (2021-01-26b1)

[dc42]

@cadetc and @Sotidii, thanks! Please try test7 from the same location.

[CadetC]

@dc42
Test7-OK

[Sotidii]

@dc42
test7=OK

[dc42]

Thanks both, please try test8.

[Sotidii]

@dc42
test8 -Ok

[CadetC]

@dc42
Test8-OK

[dc42]

Thanks again! test9 is now available.

[Sotidii]

@dc42
test9 -Ok