Pinda prob config

Phaedrux

You've removed too much. TRy this instead.

; homeall.g
; called to home all axes
;
; generated by RepRapFirmware Configuration Tool v3.2.3 on Tue Jul 27 2021 22:03:56 GMT+0300 (שעון ישראל (קיץ))
G91                     ; relative positioning
G1 H2 Z5 F6000          ; lift Z relative to current position
G1 H1 X-905 Y-905 F1800 ; move quickly to X and Y axis endstops and stop there (first pass)
G1 X5 Y5 F6000       ; go back a few mm
G1 H1 X-905 Y-905 F360  ; move slowly to X and Y axis endstops once more (second pass)
G90 ; absolute positioning
G1 X150 Y150 F6000 ; move probe to center of bed
G30 ; home Z by probing the bed

@danny777 said in Pinda prob config:

when I upload the config.g it gives me - "error; invalid use of p parameter"

Can you send M98 P"config.g" in the gcode console and report what it returns?

danny777

undefined Thank you for your response,
this what returns,

Phaedrux

I don't think you sent the correct command. Use the gcode console tab so you can see the full result.

M98 P"config.g"

danny777

Like this?

Phaedrux

Yes. Did you press enter? Or the send button?

danny777

Yes, I did

Phaedrux

"error; invalid use of p parameter"

Where do you see that?

danny777

it showes on duet panel (led screen) when i do config.g save

Phaedrux

On the gcode console tab and you send M122 and M98 P"config.g" again?

danny777

This is what i get

Phaedrux

Have you power cycled your board recently? I can't really tell what's going on from your screen shot as it doesn't appear to be updating the text.

danny777

Yes I work with the machine ,

danny777

It looks like lots of details thet i run throough the dwc showes on the console,
for exemple , when I run mesh compensation i get this

Phaedrux

Are you using a raspberry pi with your Duet?

If you look at the general tab in DWC and the machine specific tab what versions are listed for the Duet and DWC?

danny777

Im not using a raspberry pi
version - Duet Web Control 3.1.1

Phaedrux

Ok, if DWC is on 3.1.1 then I wonder what your firmware version is. Something isn't matched up.

https://github.com/Duet3D/RepRapFirmware/releases/download/3.3/Duet2and3Firmware-3.3.zip

Upload this zip file as it is to the system tab in DWC, don't extract it first. After it is finished update the firmware and reboot. Then send M122 again and see what it reports.

danny777

Did it! look better but still "error; invalid use of p parameter"
03ce6d49-eec4-4e3f-a336-bdd208f1043a-image.png

Phaedrux

Can you send M98 P"config.g" again now?

danny777

here

danny777

Now after update firmwere ,I have a new problem, if push z 5 mm up it moves down
and not all the time , once is up and once it down , same button