Pinda prob config
-
Thank you for your response,
this what returns,
-
I don't think you sent the correct command. Use the gcode console tab so you can see the full result.
M98 P"config.g" -
Like this?
-
Yes. Did you press enter? Or the send button?
-
Yes, I did
-
"error; invalid use of p parameter"
Where do you see that?
-
it showes on duet panel (led screen) when i do config.g save
-
On the gcode console tab and you send M122 and M98 P"config.g" again?
-
This is what i get
-
Have you power cycled your board recently? I can't really tell what's going on from your screen shot as it doesn't appear to be updating the text.
-
Yes I work with the machine ,
-
It looks like lots of details thet i run throough the dwc showes on the console,
for exemple , when I run mesh compensation i get this
-
Are you using a raspberry pi with your Duet?
If you look at the general tab in DWC and the machine specific tab what versions are listed for the Duet and DWC?
-
Im not using a raspberry pi
version - Duet Web Control 3.1.1 -
Ok, if DWC is on 3.1.1 then I wonder what your firmware version is. Something isn't matched up.
https://github.com/Duet3D/RepRapFirmware/releases/download/3.3/Duet2and3Firmware-3.3.zip
Upload this zip file as it is to the system tab in DWC, don't extract it first. After it is finished update the firmware and reboot. Then send M122 again and see what it reports.
-
Did it! look better but still "error; invalid use of p parameter"
03ce6d49-eec4-4e3f-a336-bdd208f1043a-image.png -
Can you send M98 P"config.g" again now?
-
here
-
Now after update firmwere ,I have a new problem, if push z 5 mm up it moves down
and not all the time , once is up and once it down , same button -
Sent m122 again , attached
console.txt
