Duet 3 mini+ red/green led keeps flashing card unresponsive
-
I came down and saw that my bl touch was flashing and printer just stopped mid print. Now i cannot get it to connect to wifi. Red and green keep blinking but stops for a few seconds and the red led by it self blink a few times then they are back to flashing. What could have happend? Running it on USB red and green are solid and i can connect through wifi.
-
not much help here but i figured out it was the powersuply.
-
@alucardi I'm glad you sorted it out.
If you get flashing LEDs again, please tell us which LEDs are flashing. There are two red and two or three green ones. I guess in this case it was the red +5V and green +3.3V ones that were flashing, not the red Status LED which flashes during normal operation.
One of our support staff is currently not working, so response to forum questions is slower than usual.
Duet WiFi hardware designer and firmware engineer
Please do not ask me for Duet support via PM or email, use the forum
http://www.escher3d.com, https://miscsolutions.wordpress.com -
@dc42 said in Duet 3 mini+ red/green led keeps flashing card unresponsive:
@alucardi I'm glad you sorted it out.
If you get flashing LEDs again, please tell us which LEDs are flashing. There are two red and two or three green ones. I guess in this case it was the red +5V and green +3.3V ones that were flashing, not the red Status LED which flashes during normal operation.
One of our support staff is currently not working, so response to forum questions is slower than usual.
Eventually i found this link https://duet3d.dozuki.com/Wiki/What_to_do_if_your_Duet_won't_respond After using that one i figured out that it must be the power supply. It was a bit hard to find, had to use google.
