EndStop - Variables declaration - Corrisponding PIN

[GiusepRap]

Hi everyone, I cannot connect easyly my Duet 3 Mini to the printer because I don't understand how can I do to pass the variable name to the pin for wiring the end-stops

[fcwilt]

@giuseprap said in EndStop - Variables declaration - Corrisponding PIN:

Hi everyone, I cannot connect easyly my Duet 3 Mini to the printer because I don't understand how can I do to pass the variable name to the pin for wiring the end-stops

What firmware are you using?

I am using firmware 3.3 on a Duet MB6HC and this is what my endstop configurations look like:

M574 Y1 S1 P"io0.in"               ; configure Y endstop on 6HC (NC switch)
M574 X1 S1 P"io1.in"               ; configure X endstop on 6HC (NC switch)
M574 Z1 S1 P"io2.in"               ; configure Z endstop on 6HC (NC switch)

Fredderick

[GiusepRap]

@fcwilt thanks for the help. I'm using the configurator Reprap for the Duet mini 5+, I've found the pin and the variables. Thanks