@fcwilt thanks for the help. I'm using the configurator Reprap for the Duet mini 5+, I've found the pin and the variables. Thanks

@Phaedrux thanks I deleted for rewriting better but I couldn’t. Thanks, now I try ti update the firmware and After I check it again. Regards Giuseppe

@dc42
I’ve installed dual z axis, x and y end extruder
but when I launch de web app the extruder command is “locked” and it cannot extrude

This is my configuration

Drives
M569 P0.0 S1 ; physical drive 0.0 goes forwards
M569 P0.1 S1 ; physical drive 0.1 goes forwards
M569 P0.2 S1 ; physical drive 0.2 goes forwards
M569 P0.3 S0

M584 X0.0 Y0.3 Z0.2:0.4 E0.1

Regards
Giuseppe

@Phaedrux thanks

I want program a cold extruder for ceramics
Regards
Giuseppe

Hi guys
I’m trying to configure my Duet Wi-Fi mini for a ceramic “cold” extruder.
How can I do ? I don’t need of temperature sensor and heater.
Regards
Giuseppe

Hi every one I' want remind the procedure that I used for understanding missing steps (if there are).

1. M584 X0.0 Y0.0 Z0.2:0.4 E0.3
   "for selecting the 2 and 3 driver for the z axes".
2. M574 Z1 S1 P"io3.in"
   "for selecting the microswitch z for the two motors"

Can I have a confirmation by someone that is better then me with the duet mini 5 plus?

Is there anything that should I change ? I ' m setting up a Prusa i3 modified.
regards
Giuseppe

@t3p3tony thanks

@t3p3tony hi I use the red endstops mechanical like this
https://www.amazon.it/Printer-Endstop-Switch-Makerbot-RAMPS1-4/dp/B07PBZW5WY
I don't understand how can I connect safety...

Hi everyone, how can I do to connect the End-stops of Makerbot to the Duet 3 mini Wifi? regards Giuseppe

@jay_s_uk thanks, but can I modify the configuration in the web page of the Duet?