Feature request: Min Power for Velocity Ramping

[rabbit]

Hi,
Meanwhile my co2 laser is working. Thanks for the great support.
I noticed that the laserpower at a contour with many small lines is much lower than with straight lines (see the picture below - the square was cut with the same laserpower as the deer ).
I think a min Power setting for velocity ramping should fix this.
Best,

[gloomyandy]

@rabbit What version of RRF did you use for that?

[rabbit]

@gloomyandy I use the latest 3.4.0 release on a Duet 3 with SBC

[dc42]

@rabbit if the speed is slowing down on curves, try increasing your X and Y jerk settings (M566).

[rabbit]

@dc42
Since the working area is quite large (1500mm x 600mm) I can't go above 300 mm/min jerk without having excesive vibrations.