Problem with simple sensor after upgrade

[Alijambo73]

I have a Corexy with 4 extruders. After the upgrade to 3.2 I'm having a problem where if I run M591 D0 it shows filament is present but when I start a print it pauses and says no filament detected E0. It worked fine before the upgrade.

I have this in my config.g "M591 D0 P1 C"e0stop" S1". I can't figure it out. I have read some references to error,g but I'm not sure what that is or if it would be related? Do I need this or is my original pause .g sufficient?

Any thoughts on the filament sensor not detecting filament after the heaters reach temp and clarification on error.g would be welcomed.

[Phaedrux]

One thread is enough. https://forum.duet3d.com/topic/28243/filament-sensor-problem-after-upgrade-to-3-2