Mesh compensation not working

gnydick

Are there any settings that would change how mesh compensation is applied?

I find that while having a very detailed height map that covers the entire print area, I still have problems.

A large section of the back right corner here, the filament doesn't even touch the build surface.

This map was made and the print was executed on a long time heat soaked bed.

fcwilt

We would need to see the code where you load the height map.

Frederick

gnydick

@fcwilt OMG, it's not on my gcode! I have no idea how it disappeared from my custom gcode. That certainly explains it.

So sorry to waste your time.

fcwilt

@fcwilt OMG, it's not on my gcode! I have no idea how it disappeared from my custom gcode. That certainly explains it.

So sorry to waste your time.

Always glad to help when I can. At the very least hopefully I don't make things worse.

Frederick

gnydick

@fcwilt well, so I tried again, entering G29 S1 after the print started, and confirmed "Mesh" on the DWC.

The front edge is super smooshed and the back edge barely touches the bed.

So, I guess I must have enabled it somewhere before, because I'm still having the same problem.

And that's contrary to the bed shape. It's, on average, lower in the front than it is in the back.

Any ideas?

gnydick

@gnydick NM, brain fart