Duet 2 Killerbee CNC with OpenBuilds INTERFACE

Novastorm

Hello,

Does anyone knows if it is possible to use then OpenBuilds CNC Interface with an Duet 2 Ethernet Controller?

The Duet 2 supports UART on the PanelDue Connector but does the Duet 2 support Gbrl 1.1?

jay_s_uk

@novastorm this won't work unless you can change the firmware on the controller to support the way RRF likes it's commands

Novastorm

@jay_s_uk
Thank you!
Maybe someone at Openbuidls can tell me, if it is possible to build a Custom Firmware for the Interface.

Sindarius

@novastorm Last I remember the OpenBuilds Interface was not open source so there's no clean way to convert it to use RRF.