Heater Calibration
-
Hello everyone
I am attempting to resolve an issue. I am a new employee working for a company that is using a Modix 3D Big 60 V3 printer with a Duet 2 WIFI board. We recently had to replace the heater cartridges (the ceramic part that heats up the extruder) but we keep running into the following error: "temperature rising much more slowly than the expected 1.6 C/sec". We have followed customer support on how to troubleshoot and have not been able to pinpoint the issue. We have replaced the heater cartridges multiple times and checked the electrical connections. I began to check the Duet documentation and says that the heaters have to be calibrated via PID and the error we receive is due to the heaters not being calibrated. There are macros on the Duet that runs the PID auto tuning but want to confirm that this is indeed the source of the error and the heater can be auto PID tuned using this board and firmware vr. If there are any other suggestions, please let me know
Tech Specs
Duet 2 Wifi
Firmware: RepRap Firmware for Duet 2 WIFI 2.05.1
Duet WIFI Server Version: 1.23 -
undefined Phaedrux locked this topic
-
Please only create a single post for your issue.
