Complete download needed for new installation… confused!
-
Good day . please tell me .I accidentally pressed the ERASE button and flew all the firmware reading on the website I realized that you need to install Bossa . I installed it but do not understand which files and where to download please tell me
-
All you need to know should be at https://duet3d.com/wiki/Updating_main_firmware#Fallback_procedure_.233. If there is anything there that you don't understand, feel free to ask again.
-
Good day . The link you advised . I did SC was listed on the page of the link . but that does not work out . can you write the process how to do it and what firmware need and do I need a flash drive for flashing process.
-
I have written the process, it's on the page I linked to. What didn't work for you? What do you mean by "SC" ?
You don't need a flash drive to install new firmware, you need either the SAM-BA program or the Bossa program in your PC as described on that page, and a USB cable between your PC and the Duet.
-
I use the Bossa program is ran the program and connected the DUET cost WIFI downloaded DuetWiFiFirmware.bin and did as said If you can't run SAM-BA (e.g. because you want to update the firmware with a Mac), you can also use Bossa 1.18 (not earlier versions) with https://github.com/shumatech/BOSSA/releases Interactive version (Bossa) does not work on high resolution screens, but you can still use the command line version (bossac). If you use the interactive version, you need to select to Wipe everything, Lock, and Boot from the Flash before pressing the Write key. If you are using the command line, try this command line: After that I pressed reset and no result
-
Did Bossa or bossac report "Verify successful"?
-
Yes exactly . report from Bossa was . now that's just . filled it with firmware 1.18 . uploaded it has disabled the usb wire put the flash drive with my settings and the result has not changed . diag lamp continues to burn
-
Ignore the diag lamp, whether it will be on or off depends on your Z probe configuration.
After programming, if you reset the board then the Bossa port will disappear from your mac but the Duet 3D port should appear.
-
tried all the firmware or what does not work . help what to do ?
-
3D-port of the Duo and not appearing Bossa program port too
-
3D port of Duo and not see Bossa program port sees. when you wipe the Boss is seen again
-
tell me what am I to do with my problem ?
-
Are saying that after flashing the firmware and restarting, you don't see the Duet 3D port in Windows Device Manager?
If so:
- Make sure you have downloaded the correct firmware file. Check that the file size is about 300K.
- Make sure that the M552 S1 command in config.g on the SD card has a semicolon in front of it to deactivate it.
- Check in Device Manager for an "Unknown device"
- If you are running Windows, you may need install the device driver from https://github.com/dc42/RepRapFirmware/tree/dev/Driver.
-
can you give me a link to the correct firmware ?
-
As it says on the wiki in several places, latest stable firmware is always at https://github.com/dc42/RepRapFirmware/releases.
