Asking for the hostname and password
-
After I could set up the WIFI and connect via the IP address m552 S1 gives you, this pops up(see image for reference).
I do not know what to do at this point. I tried every password it might be asking me to put but none of them worked out.
Note: I am using my iPhone as a hotspot since it is 2.4Hz.
Thank you for help!!
-
Do you have a M551 password set in your config.g?
https://docs.duet3d.com/en/User_manual/Reference/Gcodes#m551-set-password
-
@Phaedrux I am not sure if I do. How do I check? I am totally new to using Duet3D.
-
Well in that case it might be a good idea to spend some time in the documentation.
https://docs.duet3d.com/en/Start_Here
The Gcode wiki is also invaluable. https://docs.duet3d.com/en/User_manual/Reference/Gcodes
The central means of configuration for the Duet is the config.g file located on the SD card in the sys folder. It's normally accessible from the web interface, but in your case, with a password set, you won't be able to access the interface until you figure out what you set it to. So you'll have to pull the SD card and put it in a PC and open the config.g file in a text editor. Look for a M551 command that should have the password. You can either stick with that password, or delete the command if you don't want a password.
-
@Phaedrux Awesome!! Thank you so much for your input.
