Driver shorting to ground and movement not operating well
-
Bought a duet 3 mini 5+ some time ago and hooked it up to a tronxy x5sa. But when I try to move anything it seems like its fighting back against another motor and the web interface reports driver shorting to ground.`
Video of the behavior -
@mediterranean_diode
It's most likely wired incorrectly.
Have a good read here before going any further
https://duet3d.dozuki.com/Wiki/Choosing_and_connecting_stepper_motorsPay particular attention to the section on working out the phase pairs.
If you still have problems, report back with details and post your config.g
-
undefined mediterranean_diode marked this topic as a question
-
undefined mediterranean_diode marked this topic as a regular topic
-
undefined mediterranean_diode marked this topic as a question