wait for...

MintyTrebor

M109 - eg in PrusaSlicer : M109 S[first_layer_temperature]

M190 - eg in PrusaSlicer : M190 S[first_layer_bed_temperature]

tecno

Thanks!

I now have following in my start

M104 S[first_layer_temperature] ; set extruder temp
M140 S[first_layer_bed_temperature] ; set bed temp
M190 S[first_layer_bed_temperature] ; wait for bed temp
M109 S[first_layer_temperature] ; wait for extruder temp

A Former User

This post is deleted!

tecno

@Herve_Smith

Yes

MintyTrebor

@Herve_Smith They are prusaslicer variables or as they call them placeholders.

A Former User

This post is deleted!

A Former User

This post is deleted!

MintyTrebor

@Herve_Smith The syntax is described here

dc42

@tecno said in wait for...:

How do I setup following start gcode in slicer Prusa or Superslicer.

Have start to read temperature settings from gcodefile for bed and hotend and wait for temperatures to reach set values?

To wait for all temperatures to reach set values, use M116.

tecno

@dc42

So is this then correct?

M104 S[first_layer_temperature] ; set extruder temp
M140 S[first_layer_bed_temperature] ; set bed temp
M190 S[first_layer_bed_temperature] ; wait for bed temp
M109 S[first_layer_temperature] ; wait for extruder temp
M116

How about chamber temp if I want it to reach xC before start print?

dc42

@tecno there are multiple ways of doing it. M104, M140 and M141 set the hot end, bed and chamber temperatures respectively without waiting for them to reach temperature before proceeding to the next command. So they will all heat concurrently. Then you can use M116 to wait for them all to be reached:

M104 S225 ; set extruder temp
M140 S70 ; set bed temp
M141 S60 ; set chamber temp
M116 ; wait for all temps to be reached

Or if the hot end heats quickly but the bed and chamber heat slowly, you might want to do this instead:

M140 S70 ; set bed temp
M141 S60 ; set chamber temp
M116 ; wait for bed and chamber temperatures to be reached before heating the hot end
M104 S225 ; set extruder temp
M116 ; wait for all temps to be reached

You can substitute variables in [ ] for the actual values if the slicer supports that.

Using M104 followed by M109, or M140 followed by M190 is the old (Marlin) way of doing things.