Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

I would like to build my own copy of the Duet 6HC board.

General Discussion

3

3

199

Log in to reply

undefined

abindarraez1
last edited by

Hi,
I would like to build a number of Duet 6HC Boards. The idea is to start with the open source design and then modify the model for a number of different robots. I would like to know how should I initially upload the SW?

Any Ideas?
Best Regards
undefined 1 Reply Last reply
Reply Quote 0
undefined

dc42 administrators @abindarraez1
last edited by

@abindarraez1 on the 6HC the firmware is uploaded initially using Bossa.
Duet WiFi hardware designer and firmware engineer
Please do not ask me for Duet support via PM or email, use the forum
http://www.escher3d.com, https://miscsolutions.wordpress.com
undefined 1 Reply Last reply
Reply Quote 0
undefined

abindarraez1 @dc42
last edited by

@dc42 Thanks a lot
1 Reply Last reply
Reply Quote 0

1 / 1