Upgrade Tripodmaker
-
I powered up my ethernet board.
First thing, no network connection.
Because the Ip adres is hard coded to 192.168.1.14, and my subnet is 47.
So I had to change the IP adres to 192.16..47.80 -
I tried to calibrate.
My Z-probe sensor isn't installed yet.
I tried the manual calibration(Pressed Delta Calibration on the Machine Control), but that gives me only the possibility to change the X value, not the Z value.
Then I tried this http://www.escher3d.com/pages/wizards/wizarddelta.php and used the G-console. After calibrating things are even worse.Is there a way to do manual calibration?
-
-
Which versions of the main firmware and Duet Web Control are you using? You need to use more recent main firmware or an older version of Duet Web Control.
-
I'm using
Firmware Electronics: Duet Ethernet 1.0
Firmware Version: 1.19 (2017-08-14)
Web Interface Version: 1.19 -
Hello,
Great board, first print came out and was excellent.
No elephant feet, and the only noise is from the fans. -
Please upgrade to 1.19.2 and DWC 1.19.3 from https://github.com/dc42/RepRapFirmware/releases.
-
Hi probably a dumb question, the z probe offset is related to the nozzle or to the center of the head?
-
It's relative to the head reference point (HRP), so are the nozzle offsets you specify in the G10 command(s). You can choose the HRP to be wherever you like; but in a printer with just one nozzle it would be unusual not to chose the nozzle location as the HRP.
-
Is there any documentation available? Couldn't find it.
-
Is there any documentation available? Couldn't find it.
G31 is what you need https://duet3d.com/wiki/G-code#G31:_Set_or_Report_Current_Probe_status
-
I ment documentation on setting the head reference point.
-
You don't set the head reference point, you choose it and then set the nozzle and Z probe offsets relative to it.
-
If I understand it correctly, it's like this:
My nozzle has an offset of 9 mm X direction to the center of the head.
I can choose the reference point where I want.
For 1 nozzle that would be the nozzle.
How does the printer know it has an offset of 9 mm?
And this is important for the build plate, how do I eliminate the 9mm offset in X direction. Like I have now.When I add the 2nd nozzle,
I can choose to keep the HRP on nozzle 1, and give nozzle 2 an offset of -18 mm.
or I can set the HRP in the center of the head and gibe both nozzles a +/- 9mm offset. -
Once you have chosen the HRP, you can use the M208 S0 and M208 S1 commands to define the bed limits and your X and Y homing positions in terms of that point. That's how to get rid of your 9mm offset.
