Burned Z axis pin on board.
-
I don't see an issue with the crimped wire shown in the picture, but you can see there is some burning from a arc. The driver does'nt have a blow hole like the others did.
I'm still in the testing and setup phase on the printer so that could be it, but its been working for a few weeks with no problem.
I'll have a look at the wires from the board to the motor, The motor is a nema23 running on 1050Ma any lower it loses steps.Would a thermal video of the board powering on help? ill try to get the motor wires and board in the shot
-
I don't think a thermal video would help. I think the most important things for you to do now are:
1. Check for a short to ground or to the stepper motor casing from the wire that got burned.
2. Check whether the Z driver gets hot, when Z movement is commanded but no Z motor is connected. If so then the Z driver has failed. Assuming you are running either current stable firmware (1.19.2) or a 1.20 beta, you should also get error messages if the driver is overheating or has a shorted mosfet
-
Which M code gets the error codes again?
-
M122 produces a diagnostic report. However, if you are running firmware 1.19.2 or later, you don't need to run M122 because error messages will be generated if overheating or a short to ground is detected.
-
alright sounds good im running 1.20Beta11 so it should be good
-
So if the Z driver remains cool when you command Z movement (to enable the driver and set the current) with no Z motor connected, then the driver chip may still be OK. Check the Z motor and wiring for shorts, re-make that connection, and try again.
-
Everything thing checks out, no grounding of any coils, the driver stays cool.
No shorts found I had a electrical engineer look over it he came up the same thing.Thermal made it obvious that it's not warming up at all.
So I'll re-pin the wires and test some more
-
Ok after all that. It turns out the driver doesn't drive the Z properly skips steps and has no tourqe . Swapping in the x axis driver it works great at a lower current.
Also hooked up a scope she's a noisy one. -
I dont think the fault was my doing, but ive been wrong before. So what to do?
-
David what can we do about this?
-
If your Duet is still under warranty, email your supplier.
-
It's probably not as this will be the second time a driver has failed and the third board to shit it self.
Overall this is giving me a bad taste, what are my options if my warranty is over? I haven't even done a single print with the thing.
-
I received my replacement in September so does that mean its under warranty ?
