Axis losing homed state, using sensorless homing
-
Dear all,
I noticed that when using sensorless homing, the state of the axis being homed changes from homed to unhomed when power to the motor is shut off by M906 / M85 command in the config file. I can see how this makes sense as the motor may lose a few steps, but is there a way to circumvent this behaviour?
Kind regards
-
I believe that any axis will lose it's homed state when power to the stepper for that axis is killed.
Frederick
-
@fcwilt I see, strange that I never noticed this before, thanks for the clarification
