• Tags
  • Documentation
  • Order
  • Register
  • Login
Duet3D Logo Duet3D
  • Tags
  • Documentation
  • Order
  • Register
  • Login

PSU Tripping when Powering on Printer, Possible Stuck Mosfet

Scheduled Pinned Locked Moved Solved
Duet Hardware and wiring
2
4
172
Loading More Posts
  • Oldest to Newest
  • Newest to Oldest
  • Most Votes
Reply
  • Reply as topic
Log in to reply
This topic has been deleted. Only users with topic management privileges can see it.
  • undefined
    Superbrain8
    last edited by Superbrain8 31 Dec 2023, 08:56

    Good Morning Folks,

    Got my hands on a Duet 3 6HC and a Duet 3 3HC earlier this week and had time to wire it up yesterday.

    Vin is a 24V 200W Meanwell PSU
    5V is externaly powered over a Meanwell 5V PSU
    VIN Out0 is not connected.

    Running on 3.5.0-RC2

    Powered it up this morning to verify everything where right.
    Overall no issues, no Sparks.
    After attempting a PID tune on the Hotend the PSU tripped.
    powering down the printer and having it sit unpowered for a bit caused it to power on again.

    After some digging the PSU tripped again but since then Printer refuses to power on again.
    Removing any load from the PSU gets it to start.
    Just having the 3HC connected works also fine.
    Removing any plugged in Device from the 6HC and powering it over 24V trips the PSU
    just powering it on 24V without 5V showed a slight glow on the Out3 Status LED

    Im somewhat in a lucky Position in owning a Thermal Camera and ive took a Video of the Mosfet for Out3
    Xinf_231231_094202_924.mp4

    undefined 1 Reply Last reply 31 Dec 2023, 10:47 Reply Quote 0
    • undefined
      Superbrain8 @Superbrain8
      last edited by Superbrain8 31 Dec 2023, 10:47

      After some more digging around its only the Mosfet that gets Hot the Zenner Diode for the header too.
      in the Attached video you can see the Mosfet pulsing from the PSU resetting from the Overcurrent protection and tripping again
      measured reistance on the header is about 1 Ohm the header below about 1 MOhm

      1 Reply Last reply Reply Quote 0
      • undefined Superbrain8 marked this topic as a question 3 Jan 2024, 18:44
      • undefined
        Superbrain8
        last edited by 3 Jan 2024, 18:46

        Is there a chance to get the board RMAd?
        bought it 23.12.2023, arrived the 28th from Dold-Mechatronik

        1 Reply Last reply Reply Quote 0
        • undefined
          Phaedrux Moderator
          last edited by 3 Jan 2024, 21:27

          Please send an email to warranty@duet3d.com and CC your reseller. Include a link to this forum thread and the details of your original purchase. You'll receive a reply with a form to fill out.

          Z-Bot CoreXY Build | Thingiverse Profile

          1 Reply Last reply Reply Quote 0
          • undefined Superbrain8 has marked this topic as solved 18 Jan 2024, 17:06
          2 out of 4
          • First post
            2/4
            Last post
          Unless otherwise noted, all forum content is licensed under CC-BY-SA